|
Calculate volume and volume flow rate at
densitometer, turbine meter, prover and standard pressure and
temperature conditions. Allows entry of density at any of the above
locations and calculates the density at the three other locations.
Volume can be entered at meter, prover and standard locations and
calculates volume at the other two locations. All calculations are
made to the full 15-digit precision of the programming language.
Downer and API compressibility calculations may be selected from a
drop down box. ASTM1250D Table 54C thermal Alpha constants K0, K1 and
K2 are selected from a fluid type drop down box or you may enter
constants.
Up to four prover base volumes may be entered.
Prover physical characteristics and prover pulse count can be entered
to calculate the meter K-factor at meter and prover conditions. All
correction coefficients and volume correction factors are calculated
and displayed to assist diagnosis of flow computer errors.
Calculates a meter K-factor from the last 5 of
up to 10 prover runs. Average prover run conditions are recorded.
Observed data for five sets of meter stream
conditions are compared with calculated results with variances. The
calculations are presented in three stages for densitometer
conditions, meter conditions and flow rates.
Observed data from five prove runs are compared
with calculated results and the variances displayed.
Calculates density in accordance with
the Solartron 7915 flow computer manual using the densitometer
calibration certificate constants including high and low curve fits
for the pressure correction. Calculates density for Solartron 1762,
7830 and 7835 densitometers.
|
